- 25 -
5.1.14 Lubricate hopper act uat or :
Service Interval: 160 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Raise hopper and locate actuat or on right hand side of mainf r am e.
c) Lubricate switch actuator rod with spray type lubricant or light oil.
5.1.15 Lubricate the pivot bushings (locations shown in Figure 5):
Service I nterval: 160 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Lubricate bronze bushings on br ake handle pivot with a spray type lubricant
or light oil.
FIGURE 6
BUSHING PI VOT LOCATIONS
5.1.16 Lubricate brake rod bushings:
Service I nterval: 160 hrs.
a) St op engine, wait for all m o ving par t s t o stop, and remove k ey.
b) Unhook seat latch and tilt seat up.
c) Lubricate bronze bushings on each end of brak e r od shaft with a spray type
lubricant or a light oil (bushing s ar e located to the inside of the f lang e bearings).
5.1.17 Lubricate steer ing linkag e r od ends:
Service Interval: 160 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Tilt seat up.
c) Lubricate each end of both steering linkag e r ods with a spray lubricant or a light
oil.
5.1.18 Remove engine shrouds and clean cooling fins:
Service Interval: 80 hrs.
a) Stop engine, wait f or all moving parts t o st op, and remove key.
b) Remove cooling shroud clean-out covers from engine and clean cooling fins.
Also clean dust, dirt , and oil from exter nal sur faces of engine, which can cause
improper cooling.
c) Make sure cooling shroud clean- out covers ar e reinstalled. Oper at ing the
engine without cooling shr oud clean- out covers will cause engine damage due
to overheating.
LEFT SIDE OF UNIT SHOWN