- 32 -
FIGURE 16
TRACKING ADJUSTM ENT
h) Move t he steering levers t o the reverse position. While applying slight
pressure to t he levers, allow the steering levers t o r e t ur n to neutral. The
wheels must stop turning (or slig ht ly creep in r everse) .
i) Stop engine and wait for all moving par t s t o st op. Remove jumper wire
fr om wire harness connector and plug connector into seat switch.
j) Lower from jackstands.
Set forw ard stop bolt:
a) Remove seat deck (with seat attached) to obt ain a clear view of the
steering cont r ol shaft t o com plet e this adjustment .
b) Push the speed control lever forward to full for ward speed position.
c) If eit her steering cont r ol lever surface does not cont act t he stop bar at the full
for ward speed position, adjust the stop bolt until contact occurs. See Figure
17. Once contact occur s , turn the stop bolt one m or e full turn to prevent
bottoming of t he hydraulic pump internal stops.
FIGURE 17
FORWARD STOP BOLT ADJUSTMENT
5.2.10 Steering Cont r o l Lever Response Adj ust m ent:
a) Stop engine, wait for all moving par t s t o stop and remove key.
b) Move t he speed control lever to the full forward position.