Extron electronic DMP 44 LC manual Software Control, Installing the DSP Configurator Program

Software Control

This section describes the control software for the DMP 44 LC, including:

•Software Control

•DSP Configurator Program

Software Control

The DMP 44 LC can be controlled using the DSP Configurator software, SIS commands through HyperTerminal or DataViewer.

The DMP 44 LC has the following connection options:

•RS-232— One single stack 6-pole (shared with Digi In), 3.5 mm captive screw connector is used for bi-directional RS-232 (±5 V) serial control.

See “Rear Panel Features and Cabling,” for additional details on connecting the RS‑232 port.

•USB 2.0 — A Mini B-type USB connector located on the front panel provides high-speed USB 2.0 connectivity to a host computer, backward compatible to 1.0.

The DSP Configurator Control Program is compatible with Windows 2000, Windows XP, Windows Vista®, and provides remote control of the input gain and attenuation, output volume output adjustment, and other features.

DSP Configurator can control the DMP 44 LC via any of the two control ports, RS‑232 or USB.

Updates to this program can be downloaded from the Extron website at

www.extron.com.

Installing the DSP Configurator Program

The program is contained on the Extron Software Products DVD.

Install the software as follows:

1.Insert the DVD into the drive

2.Click the Software tab or software icon.

NOTE: If the DVD setup program does not start automatically, run Launch.exe from the DVD ROM directory in “My Computer” of the Windows

operating system.

DMP 44 LC • Software Control 51