Extron electronic DMP 44 LC manual Building a Preset, Save Preset

Building a Preset

Only elements that are highlighted (given focus) will be saved as a preset. <Ctrl + A> highlights all elements within DSP Configurator.

To build a preset, highlight the desired DSP Configurator elements (gain/processor blocks, mix-points) using standard Windows keyboard and mouse actions as follows:

1.<Left click> on the desired block to select a single block,

2.<Ctrl + left click> to select multiple blocks that are not adjacent,

3.<Shift/hold + click> on the first block and click on the last block in either a vertical column or horizontal row to select multiple blocks, and

4.Click and drag a selection rectangle to select multiple adjacent blocks in either the vertical or horizontal direction.

5.Go to Tools > Presets and select Mark All Items or press <Ctrl + A>. This marks all elements within DSP Configurator, which saves a “full” preset,

6.To save the selection see “Save Preset” below.

Save Preset

A preset may be saved in either Emulate mode or Live mode.

Saving a preset in Emulate mode stores that preset in the currently open file. The DSP Configurator file must then be saved to disk via File > Save (recommended), and/or pushed to the device after a connection is established. This differs from Live mode where the created preset is saved in real‑time to the device and becomes part of the configuration file.

To save a preset use the following instructions:

1.Highlight the desired preset block by using left click, <Ctrl + left click>, <shift + left click> or drag around the desired blocks.

2.Select Tools > Presets > Save Preset in the menu bar.

DMP 44 LC • Software Control 61