Extron electronic DMP 44 LC manual “To switch from emulate mode to live mode:”, Advanced

Push Configuration - Advanced, Push Presets, Selected

The next example shows how to customize a push to include only selected presets.

Connect the DMP 44 LC as described by steps
1 to 4 in the previous procedure for switching
from Emulate mode to Live mode (see	1
“To switch from emulate mode to live mode:”),
	1
then:

1.Select the Push radio button, then click

Advanced.

NOTE: Pressing OK at this time pushes

the currently open configuration to the DMP 44 LC.

2.Select the Custom radio button.

3.Select Push Presets.

4.Choose Selected.

5.Click OK. The Synchronize with Device dialog box appears.

6.If it is not selected, select the Push the data... radio button and click OK again.

7.If changes have been made to the DSP parameters (including mix-point, gain or processor blocks) since the last file save, the DSP Configurator prompts to save the file.

a.Click Yes to open the file selection box, see previous sections for the Save File as... dialog box instructions. Accept the name, choose an existing file name or create a new one and click OK. The new configuration is pushed to the device.

b.Click No to ignore the changes.

8.The Presets in the Configuration dialog

box opens. Select the preset configurations to push to the DMP 44 LC. A checkmark appears for each selection.

In this example, a checkmark has been placed in the 1. Input Procs and

4. Output XPA preset check boxes.

9.Press OK. The DSP Configurator program saves the configuration then updates the DMP 44 LC configuration, overwriting the configuration in the device. When the transmit and receive indicators stop flashing, the upload is complete and the DSP Configurator program is now connected live to the DMP 44 LC.

Changes to the configuration are reflected immediately in the device operation.

2

3

4

5

6

7a7b

8

9

DMP 44 LC • Software Control 66