Extron electronic GSS 100 Front panel security lockout executive mode, Front panel absolute reset

Operation, cont’d

Baud Rate menu

The Baud Rate menu is read-only without further action. The menu shows the selected baud rate for the GSS’s RS-232 port. The default setting is 9600.

To change the baud rate, press and release the Take button. The baud rate display starts blinking, and can be adjusted by rotating the Adjust/Select knob.

NThe baud rate is also selectable using SIS commands or the HTML pages. See chapter 4, SIS™ Control, and chapter 5, HTML Control and IPL File Manager.

IP address menu

The read-only IP address menu is read-only without further action. The menu shows the GSS’s IP address. The factory default IP address is 192.168.254.254.

To change the IP address, one octet at a time, press and release the Take button. The first (most-significant) octet starts blinking, and can be adjusted by rotating the Adjust/Select knob. Repeatedly press and release the Take button to cycle through the four IP address octets, enabling them for editing, one at a time.

NThe IP address is also selectable using SIS commands or the HTML pages. See chapter 4, SIS™ Control, and chapter 5, HTML Control and IPL File Manager.

Exit menu

Press and release the Next button while in the Exit menu to return the LCD to the default display cycle.

Front panel security lockout (executive mode)

The front panel security lockout limits the operation of the GSS from the front panel. When the GSS is locked, the front panel Menu and Next buttons are disabled, although the Image and Take buttons are still functional. If you push the Menu or Next button when the GSS is locked, the LCD shows X Mode Enabled for approximately 3 seconds and then returns to the default display cycle.

To toggle the lock on and off, press and hold the Image button and the Next button for approximately 2 seconds.

Front panel absolute reset

The GSS 100 can be reset from the front panel, resetting the unit to its factory default conditions and deleting all uploaded images. Reset the GSS by pressing and holding the Menu and Next buttons while applying power to the unit (figure 3-11).

Press and hold the Menu and Next buttons while you apply power to the GSS.

MENU NEXT

Continue to hold the
Menu and Next buttons
until the LCD displays	Power
the Reset message.
Reset to
Factory
Release the Menu
and Next buttons.

Figure 3-11 — System reset

3-12 GSS 100 Graphic Still Store • Operation GSS 100 Graphic Still Store • Operation 3-13