Extron electronic GSS 100 Command/response table for SIS commands, Ex! Rf, ASCII Command, Still

4-	Command/response table for SIS commands
8
	Command	ASCII Command	Response	Additional description
		(host to switcher)	(switcher to host)
GSS
	Image recall
100	Recall an image to buffer	EX!RF}	Cim•X!]	Select image X! to display.
	N It will take a few seconds between issuance of the recall command (EX!RF}) and receipt of the Cim response.
Graphic	Show the currently	ERF}	X!]	Buffer is loaded with image X!.
	displayed image
	Take	%	Tke]	Swap the displayed and buffered images using the
Still				selected effect (cut or dissolve).
	Switch effect
Store	Set the effect to cut	9*0#	Eff0]	Set the effect for switching images to cut (immediate).
	Set the effect to dissolve	9*1#	Eff1]	Set the effect for switching images to dissolve.
•	Read the effect	9#	X@]
	Set the dissolve duration	10*X##	DurX#]	Set the duration of the dissolve effect to X#.
SIS™
	Read the dissolve duration	10#	X#]	The dissolve duration is X#.
Control	Display last image	0!	Chn0]	Display the previously selected stored image.
	Source selection
	Display pass-through	1!	Chn1]	Display the pass-through input.
	View pass-through status	!	X@]	Pass-through mode is X@.
	Slide show interval
	Set slide show interval	2*X##	SliX#]	Set the display time for each image to X# seconds.
	Read slide show interval	2#	X#]	The display time for each image is X# seconds.

Command/response table for SIS commands (continued)

		Command	ASCII Command	Response	Additional description
			(host to switcher)	(switcher to host)
		Pass-through configuration
		Enable pass-through	1*1#	Pas1]	Include the pass-through input in the slide show.
		Disable pass-through	1*0#	Pas0]	Do not include the pass-through input in the slide show.
		Read pass-through status	1#	X@]	Read pass-through status:
GSS					1 = include pass-through,
					0 = do not include pass-through..
100		Auto-switch and slide show mode
		Set auto-switch and slide	4*X$#	AutX$]	Set auto-switch and slide show modes:
Graphic		show			0 = Off — Auto-switch on loss of pass-through sync
					sync is disabled. Slide show is
					and slide show are disabled.
					1 = Off/show — Auto-switch on loss of pass-through
Still					running.
					2 = On/still — On loss of sync on the pass-through
Store					input, auto-switch to display the
					the last-displayed image until pass-
•					through sync is restored.
					3 = On/show — On loss of sync on the pass-
SIS
					through input, auto-switch to run
	™
					the slide show until sync on the
Control		show status
					pass-through input is restored.
		Read auto-switch and slide	4#	X$]

SIS™ Control, cont’d

4-9