Extron electronic GSS 100 user manual Installation, cont’d, Reset button

Installation, cont’d

Patch (straight) cable

					Side 1		Side 2
				Pin	Wire color	Pin	Wire color
				1	White-orange	1	White-orange
Side	Clip Down
				2	Orange	2	Orange
	Pins	1 2 3 4 5 6 7 8	RJ-45
				3	White-green	3	White-green
			connector
				4	Blue	4	Blue
				5	White-blue	5	White-blue
				6	Green	6	Green
				7	White-brown	7	White-brown
				8	Brown	8	Brown

Reset button

F	Reset button — The Reset button initiates three levels of reset to
	the GSS. Press and hold the button while the GSS is running or
	while you power up the GSS for different reset levels.
	• Events (mode 3) reset — Hold the Reset button for
	approximately 3 seconds (the Reset LED blinks once),
	then release it and push it again to toggle events
	monitoring on and off.
	• IP settings (mode 4) reset — Hold the Reset button for
	approximately 6 seconds (the Reset LED blinks twice),
	then release it and push it again to reset the GSS’s IP
	functions.
	N The IP settings reset does not replace any user-installed

1 2 3 4 5 6 7 8

1&2 3&6 4&5 7&8

Crossover cable

		Side 1		Side 2
	Pin	Wire color	Pin	Wire color
	1	White-orange	1	White-green
Twisted
	2	Orange	2	Green
Pairs
	3	White-green	3	White-orange
	4	Blue	4	Blue
	5	White-blue	5	White-blue
	6	Green	6	Orange
	7	White-brown	7	White-brown
	8	Brown	8	Brown

firmware.

• Absolute (mode 5) reset — Hold the Reset button for

approximately 9 seconds (the Reset LED blinks three times),

then release it and push it again to restore the GSS to the

default factory conditions.

N Image files, IP settings, and user settings are all cleared

and reset to the factory default.

Figure 2-4 — RJ-45 connector and pinout tables

E	RS-232 port — Connect a computer or control system to
	this 9-pin D connector to allow remote control using the SIS
	commands (figure 2-5). See chapter 4, SIS™ Control, for details.

	PIN	RS-232	Function
	1	—	None
RS-232	2	TX	Transmit data
	3	RX	Receive data
	4	—	None
	5	Gnd	Ground
	6	—	None
	7	—	None
	8	—	None
	9	—	None

Figure 2-5 — RS-232 connector pinout

2-6 GSS 100 Graphic Still Store • Installation GSS 100 Graphic Still Store • Installation 2-7