Extron electronic SMD 101 manual Ethernet Diagnostics panel, Network Port Mapping panel

•MAC Address: — The MAC address of the connected SMD 101. The address is also available on the rear panel label.

•Reset to Default: — Resets all network configuration to default.

•Save — Saves manual network configuration changes.

•Cancel — Discards manual network configuration changes.

NOTES:

•The DHCP assigned Gateway and DNS address are retained after DHCP is deselected. They are reset using the reset button on the rear panel (see SMD 101 Rear Panel Reset on page 12) or using the web-based user interface (see Reset Device on page 42).

•The network interface restarts when changes are saved.

Ethernet Diagnostics panel

This panel provides a ping utility for troubleshooting network connection issues.

•Address to ping: — Enter an IP address (10.13.193.168) or a complete host name (www.extron.com) in this field, then click Ping to start the utility. A dialog box with the results of the ping opens.

www.extron.com

192.168.3.51

Figure 32. Network Ping Dialog

Network Port Mapping panel

This panel provides basic Ethernet configuration that includes:

•SFTP: — Set the port number for SFTP here. Check Enable to use the port.

•SIS (SSH): — SSH provides a method for a SSH client to establish a secure connection to the player at port 22023, which then supports the SIS command set.

•Telnet (Extron SIS): — The port used by DataViewer or other telnet programs to access the SMD 101. Check Enable to use the port.

•HTTP: — Set the port number for HTTP here. Check Enable to use the port.

•SNMP: — Set the port number for SNMP here. Check Enable to use the port.

•HTTPS/SSL: — Set the port number for HTTPS here. Check Enable to use the port.

NOTE: Changing or disabling this port while using the default port (80) causes a loss of the connection. Try https://<SMD101 IP> to reconnect to port 443.

•Serial Pass-through:— Set the port number for the serial pass-through feature here. Check Enable to use the port.

•Reset to Default — Click to return all port mappings to default.

Default port numbers are shown in figure 31 on the previous page. Click the checkbox after the port number field to enable the port entry in the associated port field. Click Reset to return the port number to default.

SMD 101 • Web-based User Interface 35