Extron electronic manual SMD 101 Reset Summary, SMD 101 Reset Mode Summary, Activation, Result

SMD 101 Reset Summary

The SMD 101 can be reset to default states using the rear panel reset button, the

Reset Device page of the user interface, and SIS commands. Each reset affects different configurations and local files, resetting some to factory condition and retaining others.

The reset mode summary table below details the activation, results, and purpose of each rear panel activated reset mode.

SMD 101 Reset Mode Summary

		Mode	Activation	Result		Purpose and Notes
Firmware		1	Hold in the recessed rear panel	The SMD 101 reverts to the factory		If incompatibility issues arise with
			reset button while applying	default firmware for a single power cycle.		user-loaded firmware, use mode 1
			power to the unit.			to revert to the factory default
						firmware for a single power cycle.
Factory						All user files and settings are
						maintained.
		4	Hold in the Reset button for	Mode 4:		Mode 4 is used to set
			about 6 seconds until the Power	• Sets port mapping back to factory		IP address information using ARP
			LED blinks twice (once at 3		default.	and the MAC address.
			seconds, again at 6 seconds).
Settings				• Sets the IP address back to factory		"Resetting IP Settings" appears
			Then, release and press Reset
						on a connected display.
					default (192.168.254.254).
			again within
				• Sets the subnet mask address back
			1 second*.
IP					to the factory default (255.255.0.0).
All				• Sets the gateway IP address to the
Reset
					factory default (0.0.0.0).
				•	Turns DHCP off.
				• The Reset LED on the rear panel
					of the unit flashes four times in
					succession.
		5	Hold in the Reset button for	Mode 5:		Mode 5 is useful when wanting to
Defaults			about 9 seconds until the Power	Performs a complete reset to factory		start over with configuration and
			LED blinks three times (once at			uploading, and also to replace
				defaults (except the firmware).
			3 seconds, again at 6 seconds,			events.
				• Does everything mode 4 does.
			again at 9 seconds). Then,			"Resetting SMD 101" appears on
Factory			release and press Reset again	•	Clears port configurations.
						a connected display.
			within	• Resets all IP options.
			1 second*.
				• Clears all user settings.
to
				• Clears all files from the unit.
Reset
				• The Reset LED on the rear panel
					of the unit flashes four times in
					succession.
	NOTE: * = For modes 4 and 5, nothing happens if the momentary press does not occur within 1 second.

SMD 101 • Reference Information 83