Extron electronic XPA1002, XPA2001-70V, XPA2001-100V manual See Remote Volume Control on

ÂBalanced or unbalanced stereo or mono audio input connector (XPA 2001) —

Wire the 3.5 mm 5-pin captive screw connector for balanced or unbalanced input.

Tip	L	Tip
		Ring
Sleeve		Sleeves
Tip		Tip
Sleeve	R	Ring

Unbalanced Stereo Input Balanced Stereo Input

L R

Tip

Sleeve

Unbalanced Mono Input

L	Tip
	Ring
R	Sleeve

Balanced Mono Input

L R

Do not tin the wires!

NOTE: The input connector port may be labeled one of two ways. The wiring and function are the same, whichever way your product is labeled.

INPUTSINPUTS

L(MONO) R

L (SUMMED) R

or

NOTE: For mono input on the XPA 2001, because the left and right channels are summed, only the left channel needs to be wired. No jumpering to the right channel is needed.

FRemote control connector — The 3.5 mm 5-pin captive screw receptacle is used to remotely control two functions through contact closure: See the following circuit diagram.

NOTE: The remote control port may be labeled one of two ways (see the following images). The wiring and function are the same, whichever way your product is labeled.

Pins V, C, and G (1, 2, and 3) control volume by varying the DC voltage from 0 V (full attenuation) to 10 V (maximum volume) with full muting in effect when pin C is connected to ground (pin G). Use the included 3-pin captive screw connector.

See “Remote Volume Control” on page 17.

	REMOTE
	G STANDBY
10V	50mA
V	C G

MAX

2K OHMS

10K OHMS

MIN

10V 50 mA

VOL/MUTE

or 1 2 3 4 5

STANDBY

1 V

2 C

MUTE SWITCH

3 G

MUTE

VOLUME

XTRA Series • Operation 13