A.Ribbon Configuration
The PrimeraPro Color Printer has an
To change the settings, use a pointed (but not sharp) object such as a pen or pencil. Turn the printerÕs power switch on and off to initialize the changes.
The tables below list all possible switch settings on the PrimeraPro Color Printer.
The PrimeraPro Color Printer can be set for two basic types of ribbons and for two basic types of page information: color or monochrome. The switch settings described here allow you to optimize your printer for a minimum amount of ribbon waste, depending upon which type of printing you do most often.
1.If you are going to use only color ribbon, leave SW1 off. If you are going to use only monochrome ribbon or both color and monochrome ribbon, turn SW1 on. Refer to the table below.
Appendix
A
Switch
Settings
SW1 | Printer Configuration |
|
|
OFF | Configuration #1 |
|
|
ON | Configuration #2 |
|
|
|
|
SW2 | Text Mode |
|
|
OFF | Disabled |
|
|
ON | Enabled |
|
|
(FACTORY SETTING)
(FACTORY SETTING)
SW3 | Not Used | (FACTORY SETTING IS OFF) |
|
|
|
SW4 | Not Used | (FACTORY SETTING IS OFF) |
|
|
|
TABLE A-1: Ribbon Configuration
2.In configuration #1, when color page
information is sent to the printer it will print normally. However, when monochrome page information is sent to the printer, and a color ribbon is installed, the printer will advance the ribbon to a color panel which is not yellow before printing. When monochrome information is sent to the printer, and a monochrome ribbon is
83