OBJ_BUCH-0000000123-002.book Page 23 Tuesday, August 13, 2013 9:40 AM

 

 

en

23

direction of the dust collector as well as overheating of

Declaration of conformity.

 

the power tool and the materials being sanded, empty the

FEIN declares itself solely responsible for this product

dust collector/container in time, observe the material

conforming with the relevant provisions given on the last

manufacturer’s working instructions, as well as the rele-

page of this Instruction Manual.

vant regulations in your country for the materials being

Technical documents at: C. & E. FEIN GmbH, C-DB_IA,

worked.

D-73529 Schwäbisch Gmünd

 

Operating Instructions.

The self-start lock prevents the angle grinder (see Table) from automatically restarting again, even after a brief interruption of the power supply, e. g., from a pulled mains plug.

Angle grinders with electronics (see Table) are equipped with overload and blocking protection. In case of over- load or blocking of the application tool, the power supply is interrupted. In this case, switch the power tool off, remove it from the work piece and check the application tool. Afterwards, switch the power tool on again.

WSG12-125P

WSG15-125PSQ

WSG12-125PQ

WSG15-150P

WSG15-125P

WSG15-150PQ

WSG15-125PQ

WSG15-70Inox

WSG15-125PS

 

Press the locking button only when the motor is stopped (see page 5).

Turning the machine head:

Carefully turn the machine head to the new position (see page 7) without removing it from the housing.

Repair and customer service.

When working metal under extreme operat-

ing conditions, it is possible for conductive dust to settle in the interior of the power tool.

The total insulation of the power tool can be impaired. Blow out the interior of the power tool via the ventila- tion slots frequently with dry and oil-free compressed air, and connect a residual current device (RCD) on the line side.

If the supply cord of this power tool is damaged, it must be replaced by a specially prepared cord available through the FEIN customer service centre.

The current spare parts list for this power tool can be found in the Internet at www.fein.com.

If required, you can change the following parts yourself: application tools, auxiliary handle, clamping flanges, wheel guard

Warranty and liability.

The warranty for the product is valid in accordance with the legal regulations in the country where it is marketed. In addition, FEIN also provides a guarantee in accordance with the FEIN manufacturer’s warranty declaration.

The delivery scope of your power tool may include only a part of the accessories described or shown in this Instruction Manual.

Environmental protection, disposal.

Packaging, worn out power tools and accessories should be sorted for environmental-friendly recycling.

Selection of accessories (see page 12).

Use only original FEIN accessories. The accessories must be intended for the power tool type.

AGrinding disc, flap disc

(use only with mounted wheel guard)

BCutting disc

(use only with mounted cut-off wheel guard)

CSteel wire brush, fleece backing pad

(use only with mounted wheel guard)

DBacking pad for fibre sanding sheets, fibre sanding sheets

(mount only with the provided backing-pad clamping unit; use only with mounted hand guard or wheel guard)

ESteel tapered twist brush

(use only with mounted wheel guard)

FBacking pad with Velcro, Velcro sanding sheets,

sanding fleece with Velcro attachment, sponges (use only with mounted hand guard)

GSteel cup brush, round twist brushes (use only with mounted hand guard)

Page 23
Image 23
FEIN Power Tools WSG15-70LNOX/N09 manual Declaration of conformity, Operating Instructions, Repair and customer service