Fisher & Paykel DE62T27C, DG62T27C installation instructions Connecting wiring

2

Installation instructions

4-wire connections

27

Use approved 4-wire Power Supply Cord or a 4-wire Cable for Direct Wiring as described	EN
on page 24.

1Remove the terminal block cover plate.

2Insert the power supply cable with a UL listed strain relief through the hole provided in the cabinet near the terminal block. Do not tighten strain relief screw until wiring connections are complete. Note: a strain relief must be used.

strain relief clamp sections

strain relief screws

3Remove center terminal block screw. Fig.30 Inserting the power cord

4Remove appliance ground link by removing the ground connector screw (green screw).

3

4

Note: If the appliance is moved back to a 3-wire installation the ground link must be refitted.

Remove link Fig.31 Removing screws

5Connect ground wire (green) of the power supply cord to the ground conductor green screw. Tighten screw.

6Connect the neutral wire (white) of the power supply cord to the center terminal screw of the terminal block. Tighten screw.

7Connect the red wire and black wire to the upper and lower terminal block screws marked with the letter L. Tighten screws.

7

6 5

Fig.32 Connecting wiring

7

8Refit terminal block cover by inserting the two tabs first on the rear panel of the dryer and secure cover with securing screw.

9Tighten Strain Relief screws.

8 9

Fig.33 Refitting terminal block and screws