Installation instructions
Exhaust venting
17
EN
WARNING!
Fire Hazard
Use heavy metal exhaust duct.
Do not use a plastic exhaust duct.
Do not use thin metal foil exhaust duct.
Failure to do so can result in death or fire.
1Read the exhaust section (pages 12 – 15) before installing the exhaust system to determine the maximum allowable exhaust duct length.
Do not use sheet metal screws when assembling ducting. Always use suitable duct tape. Never use plastic or thin metal foil flexible exhaust material.
2The exhaust outlet is located close to the center of the rear of the dryer. Make sure you join the exhaust duct to the dryer with duct tape only. This will prevent lint and dust from escaping from the dryer and exhaust system.
Exhaust outlet
| 4 3⁄8” | (111 mm) |
13 7⁄8” (352 mm) | 13 1⁄8” (333 mm) |
|
Fig.15 Exhaust venting dimensions |
| |
Does not include foot height
3The exhaust vent can be routed up, down, left, right or straight out the back of the dryer. Refer to diagram.
