Server features, This chapter | Nortel Networks NN44200-300 instruction

11

Chapter 2

1002rp server description

In this chapter

"Server features" (page 11) "Slot assignments" (page 15) "Network connectivity" (page 18) "Network connectivity" (page 18) "Supported peripheral devices" (page 21) Reference documents

Server features

Introduction

This section provides a general overview of the 1002rp server.

Server dimensions and weight

Height		320 mm (12.5 in.)
Width		483 mm (19 in.)

Depth (distance from front to back)
•	without front bezel	495 mm (19.5 in.)
•	with front bezel	533 mm (21 in.)


Weight of fully loaded system		45.5 kg (100 lb)

Nortel CallPilot

1002rp Server Hardware Installation

NN44200-300 01.01 Standard

5.0 23 February 2007

Copyright © 2007, Nortel Networks

Nortel Networks Conﬁdential

Image 11

Nortel Networks NN44200-300 manual Server features, This chapter, Introduction, Server dimensions and weight

Contents

1002rp Server Hardware Installation Trademarks Japan Vcci statement Information for JapanJapan Denan statement Page February Publication History Publication History Contents Contents Getting help from the Nortel Web site Getting help over the phone from a Nortel Solutions Center Getting help through a Nortel distributor or reseller Introduction Server featuresServer dimensions and weight This chapter Environmental speciﬁcations Front panel features front view without the front bezel Rear panel diagram Alarm board Overhead view of empty server showing PCI and ISA connectors Reference Documents Slot assignments 1002rp server description T1/SMDI Slot deﬁnition and slot numbering BRD20 Network connectivity Sample network setup Communication Server Sample network setup Meridian Network requirements Switch connectivityCallPilot Elan subnet and Nortel server subnet setup Meridian 1 or Communication Server 1000 systems Supported peripheral devices Remote access connectivity DeviceDescription Installation checklist Installation overview Preparing for installation Conventions for warnings To unpack the equipment Unpacking the 1002rp server To remove the front bezel What is next?Removing the front bezel and server cover Remove the front bezel see To remove the front bezel To remove the server cover To inspect the server interior Inspecting the server interior Installation and Configuration To replace the front bezel after installation is complete End Preparing for installation Equipment handling guidelines Safety precautionsSafety information AC versus DC systems Installing the second power supply module AC or DCAbout the power supply module To install the power supply module AWG DC wire gauge tables DC rack cabling Metric wire conversion Power supply installation Rack power and grounding Multiple PDUs About the power distribution unitDC power distribution rationale PDU power and grounding DC power input PDU terminal blocks and wiring diagram To bring DC power and ground into the PDU Bringing power and ground into the PDU To install the server Installing the server Required equipment Modem DIP switchesPreparing the modem DIP To set the modem DIP switches Continue with Connecting peripherals to the server Connecting peripherals to the server To connect the modem to the server To connect the server to the Elan subnet Connecting the server to the Elan subnetMedia Access Control address Server will To connect the server to the Nortel server subnet Connecting the server to the Nortel server subnet optional Requirements Installing the Nortel software feature dongleTo install the software feature dongle Before you begin Connecting the server to power Plug the server AC power cord into the server rear panel To connect the 1002rp AC server to power To connect the 1002rp DC server to power To start the server Copyright 2007, Nortel Networks Ferrites secured to an external cable Index Index Tlan Index Page 1002rp Server Hardware Installation