Nortel Networks NN44200-300 manual To connect the 1002rp AC server to power, Step Action

54Chapter 5 Installing the server and connecting the peripheral devices

Note: For details on the DC power source for 1002rp DC servers, see "Installing the second power supply module (AC or DC)" (page 34)

To connect the 1002rp AC server to power

Step Action

WARNING

The power outlets used by the CallPilot server and its peripheral devices must be connected to the same single-point ground reference as the one used by the switch with MGate cards (NTRB18CA) connected to the CallPilot server. If this requirement is not met, power transients can cause personal injury, or hardware failure, or both. Refer to the Installation and Configuration Task List (NN44200-306) for more information on single-point grounding requirements.

1Plug the server AC power cord into the server rear panel.

Nortel CallPilot

1002rp Server Hardware Installation

NN44200-300 01.01 Standard

5.0 23 February 2007

Copyright © 2007, Nortel Networks Nortel Networks Confidential