Nortel Networks NN44200-300 manual Inspecting the server interior, To inspect the server interior

Inspecting the server interior 29

2Loosen the three thumbscrews at the rear of the top cover.

3Remove the server cover by pulling the cover toward the rear of the chassis, and then lifting it up and off.

4Clip the lead from your ESD wrist strap to an unpainted metal section of the chassis.

—End—

What is next?

Continue with "Inspecting the server interior" (page 29).

Inspecting the server interior

Introduction

You should perform a visual inspection for loose components, foreign matter, or shipping damage inside the server.

CAUTION

When working with interior components, use an ESD wrist strap to protect static-sensitive components.

To inspect the server interior

Step Action

1Carefully check all the cards to ensure they are fully seated on the baseboard.

2Check for any loose wires or foreign objects, such as loose screws, inside the chassis.

3Review the slot locations (see "Slot assignments" (page 15)).

4Do one of the following:

IF	THEN
you observe any damage	contact your Nortel technical
	support representative.

Nortel CallPilot

1002rp Server Hardware Installation

NN44200-300 01.01 Standard

5.0 23 February 2007

Copyright © 2007, Nortel Networks Nortel Networks Confidential