To remove the server cover | Nortel Networks NN44200-300 specs

28 Chapter 3 Preparing for installation

—End—

To remove the server cover

Step Action

DANGER

High current inside the chassis can cause severe injury.

CAUTION

Take precautions to protect internal components. Electrostatic discharge (ESD) can render boards damaged or unusable. Wear an ESD wrist strap.

1Remove the front bezel (see "To remove the front bezel" (page 27)).

Nortel CallPilot

1002rp Server Hardware Installation

NN44200-300 01.01 Standard

5.0 23 February 2007

Copyright © 2007, Nortel Networks

Nortel Networks Conﬁdential

Image 28

Nortel Networks NN44200-300 manual To remove the server cover, Remove the front bezel see To remove the front bezel

Contents

1002rp Server Hardware Installation Trademarks Japan Denan statement Information for JapanJapan Vcci statement Page Publication History February Publication History Contents Contents Getting help over the phone from a Nortel Solutions Center Getting help from the Nortel Web site Getting help through a Nortel distributor or reseller Server features Server dimensions and weightThis chapter Introduction Front panel features front view without the front bezel Environmental speciﬁcations Alarm board Rear panel diagram Overhead view of empty server showing PCI and ISA connectors Slot assignments Reference Documents 1002rp server description Slot deﬁnition and slot numbering T1/SMDI Network connectivity BRD20 Sample network setup Meridian Sample network setup Communication Server Switch connectivity CallPilot Elan subnet and Nortel server subnet setupMeridian 1 or Communication Server 1000 systems Network requirements Remote access connectivity Supported peripheral devices DeviceDescription Installation overview Installation checklist Preparing for installation Conventions for warnings Unpacking the 1002rp server To unpack the equipment Removing the front bezel and server cover What is next?To remove the front bezel To remove the server cover Remove the front bezel see To remove the front bezel Inspecting the server interior To inspect the server interior To replace the front bezel after installation is complete Installation and Configuration End Preparing for installation Safety information Safety precautionsEquipment handling guidelines About the power supply module Installing the second power supply module AC or DCAC versus DC systems To install the power supply module DC wire gauge tables AWG Metric wire conversion DC rack cabling Power supply installation Rack power and grounding About the power distribution unit DC power distribution rationalePDU power and grounding Multiple PDUs PDU terminal blocks and wiring diagram DC power input Bringing power and ground into the PDU To bring DC power and ground into the PDU Installing the server To install the server Preparing the modem Modem DIP switchesRequired equipment To set the modem DIP switches DIP Continue with Connecting peripherals to the server Connecting peripherals to the server To connect the modem to the server Media Access Control address Connecting the server to the Elan subnetTo connect the server to the Elan subnet Server will Connecting the server to the Nortel server subnet optional To connect the server to the Nortel server subnet To install the software feature dongle Installing the Nortel software feature dongleRequirements Connecting the server to power Before you begin To connect the 1002rp AC server to power Plug the server AC power cord into the server rear panel To connect the 1002rp DC server to power To start the server Copyright 2007, Nortel Networks Ferrites secured to an external cable Index Index Tlan Index Page 1002rp Server Hardware Installation