Nortel Networks NN44200-300 manual To connect the 1002rp DC server to power, Danger, Step Action

Connecting the server to power 55

2Plug the other end into a wall receptacle or power bar.

—End—

To connect the 1002rp DC server to power

Step Action

DANGER

•Only qualified personnel can alter electrical connections.

•Ensure the power distribution unit (PDU) is turned off until you are instructed to turn it on.

1Connect the DC power cable to the server.

2Connect the other end of the DC power cable to the PDU. Use the supplied clips and screws to secure the plugs.

The following photograph shows the keyed plug of the DC power cable. This plug connects to the PDU:

Note: If you are not using a Nortel-supplied PDU, have a qualified electrician connect the cable appropriately to your DC power plant. The 1002rp uses a negative 48 V power supply, therefore the red cable is negative (-48 V) and the black cable is the ground (GND).

3Turn on the PDU.

Nortel CallPilot

1002rp Server Hardware Installation

NN44200-300 01.01 Standard

5.0 23 February 2007

Copyright © 2007, Nortel Networks Nortel Networks Confidential