26
Installation instructions
3-wire connections plus separate grounding connector
For use where local codes do not permit grounding through the Neutral wire.
Use approved
1Remove the terminal block cover plate.
2Insert the power supply cable with a UL listed strain relief through the hole provided in the cabinet near the terminal block. Do not tighten strain relief screw until wiring connections are complete. Note: a strain relief must be used.
2
Fig.27 Inserting the power cord
strain relief clamp sections
strain relief screws
3Remove center terminal block screw.
4Remove appliance ground link by removing the ground connector screw (Green screw).
5Connect a separate copper ground wire (green with yellow stripe) using the ground connector screw (Green screw). Make sure a ring terminal is used when connecting the ground wire and that the wire is firmly secured to an adequate grounding path.
3
Note: If the appliance is
4moved back to a
installation the ground link must be refitted.
Remove link
Fig.28 Connecting the wires
7
6 
5
7
6Connect the neutral wire (center) of the power supply cord to the center terminal screw of the
terminal block. Tighten screw.
7Connect the other wires to the upper and lower terminal block screws marked with the letter L.
Tighten screws.
8Refit terminal block cover by inserting the two tabs first on the rear panel of the dryer and secure cover with securing screw.
9Tighten strain relief screws.
8
9
grounding wire 
It is recommended that a qualified electrician determine that the ground path is adequate
block and tightening screws