Fluke Ti40, Ti45, Ti50, Ti55 Adjusting Brightness and Color Controls

Ti40, Ti45, Ti50, Ti55

Users Manual

enabling the infrared picture to fit inside the visible light picture (picture-in- picture).

To choose full screen or picture-in-picture view:

1.Tap F.

2.Use the MOUSE controller to position the pointer over Camera Settings on the popup menu and tap E.

3.Position the pointer over either the Full Screen or Picture-in-Picture radio button as desired.

4.Tap the TRIGGER button to accept setting change and return to scan target mode.

Or, assign the Picture-in-Picture function to a programmable button (see Chapter 2). Then, to cycle between full screen and picture-in-picture views, tap A,B, or Cas needed.

Adjusting Brightness and Color Controls

Use the brightness and color controls to adjust the visible light image according to your personal preference.

To enable high brightness and/or vivid color:

1.Tap F.

2.Use the MOUSE controller to position the pointer over Camera Settings on the popup menu and tap E.

3.Position the pointer over the VLCM tab and tap E.

You may need to position the pointer over the right or left arrow and tap Eto scroll to the VLCM tab.

4.Position the pointer over the High Brightness box; tap Eto add or remove a check mark. A check mark indicates the function is enabled.

5.Position the pointer over the Vivid Color box; tap Eto add or remove a check mark. A check mark indicates the function is enabled.

6.Tap the TRIGGER button to accept setting change and return to scan target mode.

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

5-4 FAX 781.665.0780 - TestEquipmentDepot.com