Foxconn N570SM2AA user manual Installation Instructions, IEEE 1394a Connector F13941 optional

Chapter 2 Installation Instructions

IEEE 1394a Connector: F_1394_1 (optional)

The 1394 expansion cable can be connected to either the front (provided that the front panel of your chassis is equipped with the appropriate interface) or real panel of the chassis.

Speaker Connector: SPEAKER

The speaker connector is used to connect speaker of the chassis.

Audio Connectors: CD_IN

CD_IN is Sony standard CD audio connectors, it can be connected to a CD-ROM drive through a CD audio cable.

Chassis Intruder Connector: INTR

The connector connects to the chassis security switch on the case.The system can detect the chassis intrus- ion through the status of this connector. If the connect- or has been closed once, the system will send a mes- sage. To utilize this function, set “Case Open Warning” to “Enabled” in the “Power Management Setup” secti- on of the CMOS Setup. Save and exit, then boot the op- erating system once to make sure this function takes effect.

10 9

GNDEmpty

+12V +12V

TPB -TPB +

GND GND

TPA - TPA +

21

F_1394_1

1

GND

SPKR +3.3V

SPEAKER

1CD_L GND CD_R

CD_IN

1 INTRUDERJ 2 GND

INTR

IrDA Connector: IR

This header supports wireless transmitting and recei- ving device. Before using this function, configure the s- ettings of IR Mode from the “Integrated Peripherals” s- ection of the CMOS Setup.

S/PDIF-OUT Connector: SPDIF _OUT

The SPDIF OUT Connector is capable of providing dig- ital audio to external speakers or compressed AC3 da- ta to an external Dolby digital decoder.

1

+5V Empty

IRRX

GND

IRTX

IR

1 5V Empty

1SPDIF_OUT GND

SPDIF_OUT

17