Frymaster BIGLA30 M3000 displays IS, Is Drain Clear?, CHANGE FILTER PAD prompts, misconfigured

7.2Troubleshooting Fryers

7.2.1Computer and Heating Problems

PROBLEM		PROBABLE CAUSES		CORRECTIVE ACTION
			A.	Press the ON/OFF switch to turn the
No display on the	A. Computer not turned on.		B.	computer on.
computer.	B. No power to fryer.			Verify that the fryer is plugged in and
	C.	Failed computer or other component		that the circuit breaker is not tripped.
			C.	Call your ASA for assistance.
M3000 displays IS	A filter error has occurred due to dirty or		Follow instructions on page 5-4 through 5-
VAT FULL?	clogged filter pad or paper, clogged filter
YES NO after a	pumps, improperly installed filter pan		6 to clear the filter error. If problem
	components, worn or missing O-rings,		persists, call your ASA for assistance.
filtration.
	cold oil or filter pump thermal overload.
M3000 display shows			Clear drain with Fryers Friend and press
	Drain is clogged and oil failed to drain.		9	(1) YES button. Filtration will
IS DRAIN CLEAR?			resume.
M3000 displays	Filter error has occurred, filter pad		Change the filter pad and ensure the filter
	clogged, 25 hour filter pad change prompt		pan has been removed from the fryer for a
CHANGE FILTER
PAD?	has occurred or change filter pad was		minimum of 30 seconds. Do NOT ignore
	ignored on a prior prompt.		CHANGE FILTER PAD prompts.
	A. Drain valve not fully closed.		A.	Check status of MIB – Ensure A is
	B. Gas valve is not turned on.			displayed.
	C.	Manual gas shut off valve closed.	B.	Turn the gas valve knob to the ON
	D.	Improperly connected quick-		position.
		disconnect fitting on gas line.	C.	Verify that any in-line manual shut off
	E. Obstructed or failed combustion air			and gas main valve is open.
Fryer does not heat.		blower.	D.	Verify that the quick-disconnect
				fitting on the flexible gas line is
				firmly connected to the fryer.
			E.	Verify that combustion air blower is
				running. If not, call ASA for service.
				If combustion air blower is functional,
				clean and adjust per instructions in
				Chapter 6 of this manual.
Fryer is operating			Clean and adjust per instructions in
normally, but recovery	Dirty or obstructed combustion air blower.
			Chapter 6 of this manual.
is slow when cooking.
Fryer is operating	A.	Dirty or obstructed combustion air	A.	Clean and adjust per instructions in
		blower.		Chapter 6 of this manual.
normally, but produces
	B.	Dirty or obstructed gas valve vent tube	B.	Clean per instructions in Chapter 6 of
a popping sound when		(non-CE fryers only).		this manual.
burners ignite.
	C.	Malfunctioning combustion air blower.	C.	Call your ASA.
Computer locks up.			Remove and restore power to the
	Computer error.		computer. If problem persists, call your
			ASA for assistance.
M3000 display shows			Set proper energy type. Press 1234 to
misconfigured	Energy type in fryer setup is incorrect.
			enter setup to properly configure fryer.
energy type

7-2