Frymaster cm45 s operation manual CM4-SCooking Computer - Alarm Programming, Programming Hint

CM4-S Cooking Computer — Alarm Programming

Programming Hint

Alarms are set to remind operators to shake fry baskets or tend to the product in some other way at points during the cook cycle. The instructions at right detail setting three alarms in a 13- minute cook cycle. To enter a single alarm, exit the sequence after setting the first alarm.

Three alarms can be programmed for a cook cycle. The CM4-S counts down cook times from the total time to zero. Alarms are entered at the point in the countdown they are desired. The example below is for alarms at 11:00, 6:00 and 2:00 on the countdown clock; the alarms will occur two, seven and 11 minutes into the 13-minute cook cycle.

	1:	11:00
At the Alarm 1			2:	6:00
prompt, enter
11:00. The alarm			At the Alarm 2 prompt,
will occur with 11			enter 6:00, The alarm will			3:	2:00
minutes remaining			occur with 6:00 remaining
in the cook cycle;			in the cook cycle; seven			At the Alarm 3
two minutes have			minutes have passed.			prompt, enter 2:00.
passed.						The alarm will
						occur with 2:00
						remaining in the			Cook
						cook cycle; 11
						minutes have			cycle
						passed.			ends
									13:00
2:00					7:00			11:00

Points in the cook cycle the alarms occur

g

1.After reaching the first display of Segment on the computer when programing for any mode of operation, follow these steps to set audible alarms in the cook cycle.

2.Segment is shown in the left display; Product and its number in the right. Press hidden program button (see diagram on page 2-2).

3.Alarm 1 appears in left display; A or M and a time appears in the right.

4.Determine the point in the cooktime countdown the first alarm should occur. For example, to set an alarm two minutes into a 13- minute cook cycle, set the alarm at 11:00, the time the computer will display when two minutes have elapsed in the cook cycle. (See graphic above).

5.Use to toggle between A and M. With A displayed, alarms are self-canceling; with M displayed, alarms must be canceled manually. See example on next page of entering three alarm times.

6.With desired time and alarm-canceling mode displayed, press to proceed. Skip to step 9 to program Alarm 2. To exit alarm programming follow steps 7-8.

5-1