KSCFH18E COOL ZONE SERIES ELECTRIC FRYERS
CHAPTER 3: INSTALLATION INSTRUCTIONS
3.1 Installing the Fryer
A.Initial Installation: If installed with legs, do not push against any unit edges to adjust its position. Use a pallet or lift jack to lift it slightly and place it where it is to be installed.
B.Relocating the Fryer: If relocating a fryer installed with legs, remove all weight from each leg before moving.
Note: If a leg becomes damaged during movement, contact a factory authorized service agent for immediate repair/replacement of the damaged leg.
DANGER
This fryer may tip and cause personal injury if not secured correctly in a stationary position. Drain all oil/shortening from fryer before moving. Hot oil will splash and cause severe burns upon contact.
3.2 Leg and Caster Installation
A.General
1.Install legs (front) and rigid casters (rear) near where the fryer is to be used, as neither are secure for long transit. The KSCFH18E electric fryer cannot be curb mounted and must be equipped with the legs and rigid casters provided.
2.When positioning the fryer, gently lower the fryer into position to prevent undue strain on the legs and internal mounting hardware. Use a pallet or lift jack to lift and position the fryer if possible. Tilting the fryer may damage the legs.
3.The rigid casters must be installed on the fryer rear only.
4.Proceed to Step 3.3, Leveling the Fryer, after legs and rear rigid casters are installed to ensure the fryer is level before using.
B.Leg and Rigid Caster Installation
1.Remove unit from pallet.
2.Carefully raise unit with forklift, pallet jack, or other steady means.
3.Place one lock washer on each hex head screw.
