Part Names, Getting Ready to Print | FujiFilm MP-300 instruction

Part Names

DC IN 5V	DATE button
socket	(P.39)
	SHARPEN button
USB socket	(P.38)

PictBridge lamp

	DATE lamp
ERROR lamp	SHARPEN lamp
ERROR lamp
(P.41)
	REPRINT button (P.36)
	Infrared port
Film counter
	POWER button
Low Battery lamp (P.42)
Battery cover	Photo pack confirmation window (P.23)
	Release button for
	the photo pack
Photo pack	door knob
Photo pack
door
Print eject slot
	Photo pack door knob

Getting Ready to Print

Loading the batteries

1 Open the battery cover.

2 Loading the batteries.

Match the = and - on the batteries to the markings in the battery case.

Insert the batteries - end ﬁrst.

3 Close the battery cover.

When closing the battery cover, press the door until click shut.

Getting Ready

Page 11

Image 11

FujiFilm MP-300 owner manual Part Names, Getting Ready to Print, Open the battery cover Loading the batteries

Contents

Getting Ready Printing Advanced Printing Error Easy printing of beautiful prints Features Contents Quick Start Guide PictBridge Quick Start Guide Infrared communication About IrSimple Introduction Unstable substances which can give off dangerous vapors Safety PrecautionsDisconnect the AC power adapter Never get this product wet or handle it C with wet hands Handling & CarePrinter care Never attempt to take this product X apart Handling & Care Using USB interfaceUsing the AC power adapter Photo pack and print care Do not put in the mouth. Do not cut Do not pull apart RestrictionsFinishing prints Batteries Optional AC Power AdapterAC power adapter AC-5VX sold separately P.14 Necessary Items Getting Ready to Print Open the battery cover Loading the batteriesClose the battery cover Part Names Close the photo pack door Loading the photo packPhoto pack conﬁrmation window Open the photo pack door Printing Setting up for infrared transmissionsPrinting Infrared communication Recommended image sizes for transmission Sending images from a camera phoneSelect the image on the mobile phone Select infrared transmission Printing PictBridge Setting up for USB transmissionsSelect PictBridge in the digital camera’s USB setting Take the film out when film output ends Press the Reprint button When all the specified imagesIf 2 or more prints are set at the camera Turn the printer off Printable image sizes and formats Supported print SpecificationsAdditional Information and Notes on Printing PictBridge print speciﬁcation compatibility table Remove the photo pack When the Film Runs OutWhen the ﬁlm runs out while printing Check that the film counter shows Check that the printer is turned off Erasing the stored imageCheck that the printer is turned on Press the Date button Sharpen Mode Date ModePress the Sharpen button Blinking 3 times Error Error lampWhen PictBridge is used Date printing position Lit Error LOW Battery lampTroubleshooting Troubleshooting printer problems Troubleshooting Troubleshooting infrared communication problems Troubleshooting USB communication problems Glossary Troubleshooting problems with finished prints Jpeg Speciﬁcation About Mobile Printing Ready Products Speciﬁcation

FujiFilm MP-300 owner manual Part Names, Getting Ready to Print, Loading the batteries

Models: MP-300