Necessary Items, Optional AC Power Adapter | FujiFilm MP-300

Necessary Items

Batteries

Two CR2 lithium batteries

●! All batteries must be new and be the same size and type.

Use following ﬁve manufacturers.

1.FUJIFILM 2. PANASONIC 3. SANYO

4.DURACELL 5. Energizer

CAUTION

Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instruction.

x With new batteries, the MP-300 will print around 100 photosc when only infrared communication is used and around 70 photosc when only USB communication is used (under FUJIFILM test conditions).

cPrint numbers may vary depending on image (ﬁle) size, operating temperature, etc.

Photo pack

Purchase the “FUJIFILM Mobile Printer Photo Pack” or the “FUJIFILM instax digital film (pivi)”.

●! No other type of photo can be used.

xEach photo pack contains 10 sheets of ﬁlm.

< Front >

< Back >

Unused check window

Optional AC Power Adapter

The AC power adapter AC-5VX (sold separately) (P.14)

The AC power adapter AC-5VX

(AC100 to 240V, 50/60Hz)

x Recommended for use when sending images from a digital camera via USB cable.

Connection

Getting Ready

18

19

Image 10

FujiFilm MP-300 owner manual Necessary Items, Optional AC Power Adapter, Batteries, Photo pack

Contents

Getting Ready Printing Advanced Printing Error Features Easy printing of beautiful prints Contents Quick Start Guide Infrared communication Quick Start Guide PictBridge Introduction About IrSimple Disconnect the AC power adapter Safety PrecautionsUnstable substances which can give off dangerous vapors Never attempt to take this product X apart Handling & CarePrinter care Never get this product wet or handle it C with wet hands Photo pack and print care Using USB interfaceUsing the AC power adapter Handling & Care Finishing prints RestrictionsDo not put in the mouth. Do not cut Do not pull apart Necessary Items Optional AC Power AdapterAC power adapter AC-5VX sold separately P.14 Batteries Part Names Open the battery cover Loading the batteriesClose the battery cover Getting Ready to Print Open the photo pack door Loading the photo packPhoto pack conﬁrmation window Close the photo pack door Printing Infrared communication Setting up for infrared transmissionsPrinting Select infrared transmission Sending images from a camera phoneSelect the image on the mobile phone Recommended image sizes for transmission Take the film out when film output ends Setting up for USB transmissionsSelect PictBridge in the digital camera’s USB setting Printing PictBridge Turn the printer off When all the specified imagesIf 2 or more prints are set at the camera Press the Reprint button PictBridge print speciﬁcation compatibility table Supported print SpecificationsAdditional Information and Notes on Printing Printable image sizes and formats Check that the film counter shows When the Film Runs OutWhen the ﬁlm runs out while printing Remove the photo pack Check that the printer is turned on Erasing the stored imageCheck that the printer is turned off Press the Sharpen button Sharpen Mode Date ModePress the Date button Date printing position Error Error lampWhen PictBridge is used Blinking 3 times Troubleshooting printer problems Error LOW Battery lampTroubleshooting Lit Troubleshooting infrared communication problems Troubleshooting Troubleshooting USB communication problems Troubleshooting problems with finished prints Glossary Speciﬁcation Jpeg Speciﬁcation About Mobile Printing Ready Products