PRINTING - PictBridge -
4
Turn the digital camera off and then disconnect the USB cable.
If 2 or more prints are set at the camera
If 2 or more prints have been specified, take the film out after the first image has been printed and then proceed as described below.
Turn off | 5 |
x
Turn the printer off.
If you are using the AC power adapter, turn the printer off before disconnecting the adapter.
1
BlinkingLit
2
x
Check that the POWER button is lit and that the PictBridge lamp is blinking.
Press the REPRINT button.
When the PictBridge lamp is blinking, pressing the REPRINT button prints the next selected image.
Printing
3 Take the film out when film output ends.
◆ Recommended ◆
x If the film counter decrements to “0” while the specified images are being
The use of an AC power adapter (optional
Lit (POWER button)
printed, see “When the film runs out while printing”. (P.35)
x Do not disconnect the USB cable or AC power adapter or turn the power off until printing has finished.
x The location of the digital camera’s USB socket, its image transmission procedures and operation procedures all differ depending on the camera
30model used. Refer to the owner’s manual for your camera.
Repeat steps 1 to 3 until all the images have been printed.
Lit | Lit | When all the specified images |
|
| have been printed, the PictBridge |
|
| lamp stops blinking and stays lit. |
x Do not disconnect the USB cable or AC power adapter or turn the digital camera off until all the images have been printed.
31
