Suspending the System
You can conserve battery power by suspending the system when you are not using the pen tablet. Suspending the system allows you to stop the system without closing files or exiting programs that are open or running.
To suspend the system,
1.Choose one of the following:
•If the Suspend/Resume button on your system is configured to use the Normal setting, press the Suspend/Resume button or carry out the Suspend command in your operating system or application software.
•If the Suspend/Resume button on your system is configured to use the Power On/Off or Resume Only setting, carry out the Suspend command in your operating system or application software.
If you are not sure how the Suspend/Resume button is configured, contact your local help desk for assistance.
2.Wait for the system to suspend operation; it may take a few seconds. The pen tablet emits a double beep (if the speaker is on) just before entering Suspend mode.
Do not press the Suspend/Resume button repeatedly, more firmly, or hold it down continuously. Doing so will interrupt the suspend procedure.
3.Observe the Power LED. If the LED is blinking once every 4 seconds, the system is in Suspend mode.
Once system operation is suspended, you can:
•Remove the battery pack from the pen tablet and install a charged battery pack. (The bridge battery in the pen tablet will provide sufficient power in Suspend mode for about 3 minutes.) To prevent losing unsaved data, wait until system operation is suspended before you remove the battery pack.
•Connect or disconnect peripherals from the pen tablet.
•Resume system operation by pressing the Suspend/Resume button as described earlier.
Using the Point 1600 Pen Tablet |
