Fujitsu BX600 SB9 manual

White Paper ⏐ Issue: October 2006 ⏐ Integration of BX600 SB9 Switches in Cisco Networks

Page 30 / 47

Select "Switch Fault Tolerance" and press “Next”

Press "Finish"

Image 30

Fujitsu BX600 SB9 manual Select Switch Fault Tolerance and press Next Press Finish

Contents

Contents Introduction Switch Connectivity Basic Multicast ServicesSwitch Management Page Introduction Recommended Solution ConfigurationAuto Negotiation Network problems Port Aggregation Set up the port-channel Shut down the affected ports to avoid loops Bring up the affected ports Verify the operation of the port-channels Vlan Trunk between SB9 and Cisco Switch VLANs and Trunks Configure the port-channels Configure Vlan trunkDefine the VLANs Verify the Vlan trunk Gvrp Spanning Tree Protocol Running ST P 802.1D with PVST+ on Vlan Trunks SB9 Running PVST+ on Vlan Trunks while disabling STP at the SB9 Combining RAPID-PVST and 802.1w Rapid Spanning Tree Combining RAPID-PVST and 802.1w after failure of Po1 Configure the switches SB9 SwitchConfiguration with Vlan Trunks Network loopsPage Page Verify the configuration STPPage Configuration example Rstp without Vlan trunks Configuration without Vlan TrunksPage Mode Type State Role Enabled Forwarding Designated Disabled Enabled Disabled PC Mbr Manual forwarding Interface Access Port and NIC Configuration BX600 port mapping Typical access port configuration Configure the access ports of the switches Configure the Broadcom NIC Page Configure the Intel Adapter Page Select Switch Fault Tolerance and press Next Press Finish Configure a Link State Group Link State Enable multicast routing and Igmp at the layer 3 switch Recommended solutionConfiguration Enable Igmp snooping at all Layer 2 switches Vlan Page Configure the SB9 for broadcast Sntp Configuration of syslog and SntpConfigure the SB9 for unicast Sntp Configure the SB9 for logging and syslog Test the configuration Configure SNMPv3 authentication Configuration of SnmpConfigure Snmp for SNMPv1 and SNMPv2c Snmp Configure the SB9 Remote Console AccessConfiguration of SSH Test the login Configuration of Radius Integration into Radius and TACACS+Prepare the ACS Page Specify the user’s password and press Submit Test the login Configuration of Tacacs Page Configure the SB9 Configuration of CDP Check the configurationCisco Discovery Protocol Configuration of Port Monitoring Port MonitoringFurther information in the Internet