Configure the Intel Adapter | Fujitsu BX600 SB9 specs

White Paper ⏐ Issue: October 2006 ⏐ Integration of BX600 SB9 Switches in Cisco NetworksPage 28 / 47

Step 3: Configure the Intel Adapter

To configure the Intel NIC, open the “Local Area Connection Properties” for the first adapter.

Press ”Configure”

Select the “Teaming” tab

Image 28

Fujitsu BX600 SB9 manual Configure the Intel Adapter

Contents

Basic Multicast Services Contents Introduction Switch ConnectivitySwitch Management Page Introduction Configuration Recommended SolutionAuto Negotiation Network problems Port Aggregation Set up the port-channel Shut down the affected ports to avoid loops Bring up the affected ports Verify the operation of the port-channels Vlan Trunk between SB9 and Cisco Switch VLANs and Trunks Configure Vlan trunk Configure the port-channelsDefine the VLANs Verify the Vlan trunk Gvrp Spanning Tree Protocol Running ST P 802.1D with PVST+ on Vlan Trunks SB9 Running PVST+ on Vlan Trunks while disabling STP at the SB9 Combining RAPID-PVST and 802.1w Rapid Spanning Tree Combining RAPID-PVST and 802.1w after failure of Po1 SB9 Switch Configuration with Vlan TrunksConfigure the switches Network loopsPage Page Verify the configuration STPPage Configuration example Rstp without Vlan trunks Configuration without Vlan TrunksPage Mode Type State Role Enabled Forwarding Designated Disabled Enabled Disabled PC Mbr Manual forwarding Interface Access Port and NIC Configuration BX600 port mapping Typical access port configuration Configure the access ports of the switches Configure the Broadcom NIC Page Configure the Intel Adapter Page Select Switch Fault Tolerance and press Next Press Finish Configure a Link State Group Link State Recommended solution ConfigurationEnable multicast routing and Igmp at the layer 3 switch Enable Igmp snooping at all Layer 2 switches Vlan Page Configuration of syslog and Sntp Configure the SB9 for unicast SntpConfigure the SB9 for broadcast Sntp Configure the SB9 for logging and syslog Test the configuration Configuration of Snmp Configure Snmp for SNMPv1 and SNMPv2cConfigure SNMPv3 authentication Snmp Remote Console Access Configuration of SSHConfigure the SB9 Test the login Integration into Radius and TACACS+ Configuration of RadiusPrepare the ACS Page Specify the user’s password and press Submit Test the login Configuration of Tacacs Page Configure the SB9 Check the configuration Configuration of CDPCisco Discovery Protocol Port Monitoring Configuration of Port MonitoringFurther information in the Internet