Fujitsu BX600 SB9 manual Configuration example Rstp without Vlan trunks

White Paper ⏐ Issue: October 2006 ⏐ Integration of BX600 SB9 Switches in Cisco Networks								Page 20 / 47
	Hello Time		1	sec	Max Age 11	sec	Forward Delay	8 sec
	Aging Time 300
Interface	Role Sts Cost				Prio.Nbr Type
---------------- ---- --- --------- -------- --------------------------------
Po2	Altn BLK		3		128.640	P2p
Po3	Root FWD		3		128.616	P2p
VLAN0020
Spanning tree enabled protocol rstp
Root ID	Priority	20
	Address	0017.9470.3200
	Cost	3
	Port	616 (Port-channel3)				sec	Forward Delay	8 sec
	Hello Time		1	sec	Max Age 11
Bridge ID	Priority	4116			(priority	4096	sys-id-ext 20)
	Address	000f.247b.d080				sec	Forward Delay	8 sec
	Hello Time		1	sec	Max Age 11
	Aging Time 300
Interface	Role Sts Cost				Prio.Nbr Type
---------------- ---- --- --------- -------- --------------------------------
Po2	Altn BLK 3				128.640	P2p
Po3	Root FWD 3				128.616	P2p

2.4.4Configuration without VLAN Trunks

You set up the scenario shown in Figure 8 by performing the following steps:

∙Step 1: Configure the switches

∙Step 2: Verify the configuration

Cisco A

priority 0 for all vlans

Designated port

forwarding Po1

0/12

0/11Po1

SB9

RSTP enabled

Designated port		Root port
		forwarding
forwarding
Po3			Po3
	Gi 0/23	Gi 0/23
	Gi 0/24	Gi 0/24
Gi 0/1
Gi 0/1
			Po2

Po2

0/13

0/14

Cisco B

priority 4096 for all vlans

Alternate	Gi 0/2
discarding	Gi 0/1

No Trunks

Figure 9 : Configuration example RSTP without VLAN trunks

Step 1: Configure the switches

!SB9 configuration

!Enable RSTP for the whole switch spanning-tree

spanning-tree mode rstp

!Definine the port-channels

port-channel Po1 interface 1/1 exit interface 0/11 channel-group 1/1 exit

interface 0/12