Fujitsu DL9300, DL9400 Table, Options, and Options, Print Head Gap, USING SETUP MODE, Required Options (Cont.), Adjustment Items and Options, See the section Hardware Items and

USING SETUP MODE

	Table 5.2	Required Options (Cont.)
Function	Item		Option
HARDWRE	FORMAT		If you have a serial interface, the serial
	BAUD-RT		interface options selected on the printer
	PROTOCL		must be the same as the settings you
	DSR		selected using your software or your
	DUPLEX		computer operating system. If the
			settings are not the same, the printer
			will not print or will print garbage.
			See the section Hardware Items and
			Options later in this chapter.
ADJUST	None		If you are not using software to specify
			the top margin of the page, use the
			printer’s default top-of-form setting, 1
			inch (25.4 mm) from the top of the paper.
			If you are using software to specify the
			top margin of the page, change the
			default setting to 1/6 inch (4.2 mm).
			See the section Print Position Adjust-
			ment Items and Options later in this
			chapter.
CONFIG	None		You can change the printer’s primary
			configuration.
			See the section Configuration Items
			and Options later in this chapter.
				Setup
GAP-ADJ			the gap, change the setting.
			If you adjust the gap manually or fix	Mode
			See the section Print Head Gap
			Adjustment Items and Options.

User's Manual 5-13