Fujitsu DL9300, DL9400 NOTE, Procedure, EXITING AND SAVING, 1. Print the <<FUNCTION>> menu, 2.Select the SAVE/END function, previous default settings are used

USING SETUP MODE

EXITING AND SAVING	This section describes how to exit setup mode save any changes you
	made:
	To exit setup mode immediately, select the SAVE & END function.
	Any settings changed while in setup mode are saved as the new
	power-on defaults for the printer. The new defaults remain active
	until you change them again.
	NOTE
	The only way to exit setup mode without saving your changes is to
	turn off the printer. When you turn the printer back on, the
	previous default settings are used.
	Procedure
	To exit setup mode and save your changes using SAVE/END,
	proceed as follows:
		1. Print the <<FUNCTION>> menu.
		The <<FUNCTION>> menu should be the last printed line on
		the page. If the menu is not printed, press the ONLINE button
		to print the menu. If you are using the SELF-TST or HEX-
		DUMP function, press the FRONT DIR button instead of the
		ONLINE button to print the menu. The <<FUNCTION>>
		menu is shown below:
				<<FUNCTION>>
SAVE&END	MENU1	MENU2	HARDWRE	ADJUST CONFIG DEFAULT
LIST	SELF-TST	HEX-DUMP	V-ALMNT	GAP-ADJ

2.Select the SAVE/END function.

Make sure that the red cursor is positioned under SAVE & END. Press the −MICRO button or the ↓MICRO button to

select SAVE & END. The printer exits setup mode and returns online (the ONLINE indicator lights green). Any changes you made while in setup mode are saved.

5-40 User's Manual