Fujitsu DL9300, DL9400 data, Items, NOTE:, HARDWRE, Options, Number of, Number of, data bits, stop bits, Parity bit, Description, Serial Interface Items

USING SETUP MODE

Table 5.4 HARDWRE Items and Options (Cont.)

NOTE: Underlined options are the factory defaults.

HARDWRE	Options	Description
Items
<BUFFER>		NOTE:
(continued)		• 0BYTE option is recommended
		only for graphics application.
		• With 96KB selected, the printer
		cannot accept any download font
		data.
<PIN-18>	N/C:	Does not out put +5V to pin 18 of the
		Centronics cable.
	+5V	Outputs +5V to pin 18 of the
		Centronics cable.
<INTRFCE>		Selects the type of the interface to the
		computer.
	PARALEL	Centronics parallel interface
	SERIAL	RS-232C serial interface
	AUTO-2S	Auto interface selection mode
	AUTO-4S	Both interfaces are ready for
	AUTO-6S	communication.
	AUTO10S	Specify the timing of regarding the
	AUTO15S	selected interface as being inactive.
	AUTO20S

Serial Interface Items. The following <FORMAT> to <DUPLEX> items are not printed when you select the PARALEL option for the <INTRFCE> item. Be sure that the options selected on the printer are the same as the options selected using your computer operating system or your software. Refer to the documentation provided for your computer and software.

<FORMAT>		Number of		Number of
		data bits	Parity bit	stop bits
	8NONE 1	8	None	1
	8NONE 2	8	None	2
	8EVEN 1	8	Even	1
	8ODD 1	8	Odd	1
	7EVEN 1	7	Even	1
	7ODD 1	7	Odd	1
	7MARK 1	7	Mark	1

Mode Setup

User's Manual 5-29