Fujitsu DL9300, DL9400 Mode, Options, AND OPTIONS, Description, CONFIG Items, USING SETUP MODE, CONFIGURATION ITEMS, reffered to Setup Mode Example

USING SETUP MODE

CONFIGURATION ITEMS	The CONFIG function defines the printer’s primary configuration.
AND OPTIONS	You can set the following options to ensure that the printer meets
	your requirements:
	• Tear off for continuous forms
	• Autoloading of single sheets
	• Direct decoding of certain commands
	• Settings for feeding, printing and ejecting
	Table 5.6 describes the CONFIG items and options. Items are listed in
	the order they are printed. The procedure for changing the options is
	reffered to Setup Mode Example.

Table 5.6 CONFIG Items and Options

NOTE: Underlined options are the factory defaults.
CONFIG Items	Options	Description
<TEAROFF>		Auto or manual tearoff feed.
	MANUAL	Automatic tearoff feed is invalid,
		and tearoff feed must be done using
		the TEAR OFF button.
	AUTO	Automatic tearoff feed is valid but
		only for continuous forms. Tearoff
		feed can also be done using the
		TEAR OFF button.
<TEARPOS>		Tearoff position.
	VISIBLE	Select this option when your
		software positions forms to the next
		top-of-form after printing the last
		data. The printer performs tearoff
		feed without adding a form feed	Setup
		when data transfer has stopped.
	ALWAYS	Select this option when your soft-	Mode
		ware stops after printing the last
		data. The printer performs tearoff
		feed after adding a form feed when
		data transfer has stopped.

User's Manual 5-35