Fujitsu manual 6, 7

Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
750
6After registering the IP address is complete, click the [Set] button.
→A confirmation screen appears.
7Click the [OK] button.
→The network environment setting starts.
•When specifying the IP address or the subnet mask, note the following:
-IP addresses must be specified with the IPv4 format
-The IP address of the RMT port must be in a different subnetwork from the MNT port
-Specify the IP address of the Slave CM when connecting to the Slave CM. The IP address of the
Slave CM must be in the same subnetwork as the Master CM
-Specify the IP address of "Gateway" when allowing access from outside of the subnetwork. The
IP address must be in the same subnetwork as the port
-For "Allowed IP List", specify the IP address or the network address that allows access to the
ETERNUS DX Disk storage system. These settings are not required for access from the network
address (same subnetwork) which the ETERNUS DX Disk storage system belongs to
•Click the [Clear] button to delete setting parameters.
•When using the ETERNUS DX80 S2/DX90 S2, the MNT port setting cannot be deleted.
•When using the ETERNUS DX410 S2/DX440 S2 or the ETERNUS DX8100 S2/DX8700 S2, the FST port
setting cannot be deleted.