Fujitsu manual 1, 3

Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
902
11.2.10.1 Enable Audit Log
This function enables the audit log function.
The procedure to enable the audit log function is as follows:
Procedure
1Click [Enable Audit Log] in [Action].
→A confirmation screen appears.
2Click the [OK] button.
→Enabling of the audit log starts.
3Click the [Done] button to return to the [Audit Log] screen.
End of procedure
•Enable the "Audit Log" setting, and then specify the destination external server. Refer to "11.2.10.3 Setup
Audit Log" (page 903) for details. Audit logs are sent after the external server is specified.
•Note that the ETERNUS DX Disk storage system does not save the audit log. The audit log is only sent to
the specified external server.
The conditions for collecting audit logs are as follows:
•The interface must be GUI, CLI, or software that accesses the ETERNUS DX Disk storage system via CLI or
SMI-S
•The user who logs in or is newly logged in when the external server is set after the "Audit Log" is enabled
•Audit log collection target operations (*1)
*1: Refer to "11.1.9 Audit Log" (page 728) for details about log collection target operations.
If the audit log function has already been enabled, [Enable Audit Log] cannot be clicked.