fDBD (disable block descriptor): Byte 1
When the DBD bit is 1, the target must not return the mode descriptor block in the Data In phase. When this bit is 0, the target may or may not return the block.
This bit must be 0.
fPC (page control): Byte 2
PC specifies the type of parameter returned, defined as follows:
PC | Parameter type |
|
|
00 | Current value |
|
|
01 | Changeable value |
10Default
11Saved value
Only 00 (current value) can be set. Other values cause the following error:
Status: B©00001 (CHECK CONDITION)
Sense key: X©05 (ILLEGAL REQUEAT)
Page code: Byte 2
The page code specifies the page to be reported. The following are supported:
Page code | Description |
|
|
X©00 | Dont care (IGNORE) |
|
|
X01 | Reserved |
|
|
X©02 | Not supported |
|
|
X©03 | Not supported |
|
|
X©04 to X©3D | Reserved |
|
|
X©3D | Lamp timer |
|
|
X©3E | Job separation sheet |
|
|
X©3F | Reserved |
|
|
fAllocation length: Byte 4
The allocation length specifies the storage area allocated by the initiator for the mode sense data in bytes.
0 means no data is transferred. This is not an error.
4 $ 85