When this scanner receives the INITIATOR DETECTED ERROR message, this scanner enters the MESSAGE IN phase and sends the RESTORE POINTERS message to the initiator. Then this scanner returns to the original phase and makes a retry.
After issuing the RESTORE POINTERS message, this scanner takes action as shown in the following table.
ATN detection | Action | |
phase | ||
| ||
|
| |
SELECTION | Moves to the BUS FREE phase | |
|
| |
COMMAND | Discards the CDB already received and returns to the | |
| COMMAND phase | |
|
| |
DATA OUT | Discards the data already received and returns to the DATA OUT | |
| phase | |
|
| |
DATA IN | f When transferring image data, enters the DATA IN phase. | |
| If the memory option is provided, transfers image data again. | |
| If no memory option is provided, moves to the STATUS phase | |
| (Check Condition) Æ MESSAGE IN phase (Command | |
| Complete) Æ BUS FREE phase and keeps the sense key X©B | |
| (Aborted Command). | |
| f When transferring inquiry data or sense data, returns to the | |
| DATA IN phase and transfers data again | |
|
| |
STATUS | Returns to the STATUS phase and sends the status byte again | |
|
| |
MESSAGE OUT | Ignores this message (does not issue the RESTORE POINTERS | |
| message) | |
|
| |
MESSAGE IN | Returns to the MESSAGE IN phase and sends the message byte | |
| again | |
|
|
(3)ABORT (X©06) : MESSAGE OUT phase (initiator Æ target)
The initiator requests the target to clear the input/output operation of the specified I/O unit (i.e., the input/output operation ordered by the initiator that issued this message) and to move to the BUS FREE phase. Input/output operations ordered by other initiators are not affected.
If a logical unit is not identified before the ABORT message, the target merely moves to the BUS FREE phase.
If no operation to be cleared, an error does not occur.
The initiator does not intend to issue another message by activating ATN before it deactivates the ACK of the ABORT message.
4 $ 91