Fujitsu MHV2080AS, MHV2060AS, MHV2040AS manual Interface

Interface

Bit 5: *	'1' = Supports the General Purpose Logging feature set
Bit 4:	'1' = Valid Configure Stream command has been executed
Bit 3-2:	Reserved
Bit 1:	'1' = Supports the SMART SELF-TEST.
Bit 0:	'1' = Supports the SMART Error Logging.
*18 WORD 88
Bit 15-8:	Currently used Ultra DMA transfer mode
	Bit 13: '1' = Mode 5 is selected.
	Bit 12: '1' = Mode 4 is selected.
	Bit 11: '1' = Mode 3 is selected.
	Bit 10: '1' = Mode 2 is selected.
	Bit 9: '1' = Mode 1 is selected.
	Bit 8: '1' = Mode 0 is selected.
Bit 7-0:	Supportable Ultra DMA transfer mode
	Bit 5: '1' = Supports the Mode 5
	Bit 4: '1' = Supports the Mode 4
	Bit 3: '1' = Supports the Mode 3
	Bit 2: '1' = Supports the Mode 2
	Bit 1: '1' = Supports the Mode 1
	Bit 0: '1' = Supports the Mode 0
*19 WORD 89 (Value ⋅ 2 minutes)
MHV2080AS = X'28':		80 minutes
MHV2060AS = X'1E':		60 minutes
MHV2040AS = X'14':		40 minutes
*20 WORD 93
Bits 15:	= 0
Bit 14:	= '1'
Bit 13:	'1' = CBLID- is a higher level than VIH (80-conductor cable).
	'0' = CBLID- is a lower level than VIL (40-conductor cable).
Bits 12-8:	In the case of Device 1 (slave drive), a valid value is set.

5-86 C141-E221