E-5

English

HOW TO USE ACCESSORIES

Cable clampers

Use the supplied cable clampers to bind the display’s signal or power cables. Use them as shown in the figure when mounting the display
on the wall, using the wall-mounting unit, or hanging it from the ceiling using the hanging unit.
ACCESSORIES
Information
Cables for connecting the display to external equipment are not supplied. Contact your dealer for more information on these products.
When you run signal cables
downwards When you run signal cables to the right
Projections (to be fit into corresponding
sections on the display)
One connector cover
Two cable clampers
One remote control One strap
(for remote control) Two AA batteries One user’s manual
Three large and
two small ferrite cores
(with wire clampers)
Four screws
(screw A x 2, screw B x 2) Three power cables

CHECKING ACCESSORIES

Manual

Connector cover

When you finish binding the cables using the cable clampers, you need to attach the
connector cover to the display.
To do this, use nippers to cut out a section of the connector cover such that the cables can
be pulled out through that section. Then attach the cover to the display.
When attaching the connector cover, make sure that the upper and lower projections on
the cover fit properly into the corresponding sections on the display.
Four safety brackets
(types A x 2, type B x 2)
Screw B
(20 mm)
Screw A
(10 mm)