Fujitsu S7210 manual Memory Problems, Modem Problems, USB Device Problems, ExpressCard Problems

L i f e B o o k S 7 0 0 0 N o t e b o o k

Problem	Possible Cause	Possible Solutions
You have installed an	Your operating system soft-	Check your device and operating system docu-
external keyboard or	ware is not set up with correct	mentation and activate the proper driver.
mouse, and it does not	software driver for that device.
seem to work.
(continued)
You have connected an	Your operating system soft-	Check your device and operating system
external keyboard or a	ware is not setup with correct	documentation and activate the proper driver.
mouse and it seems to be	software driver for that device.
locking up the system.
	Your system has crashed.	Try to restart your notebook.
Memory Problems
Your Power On screen does	Your memory upgrade module	Remove and re-install your memory upgrade
not show the correct	is not properly installed.	module. (See Memory Upgrade Module on page 44
amount of installed		for more information)
memory.
	You have a memory failure.	Check for Power On Self Test (POST) messages.
		(See Power On Self Test Messages on page 59 for more
		information)
Modem Problems
Messages about modem	Messages about modem	See your application software documentation for
operation.	operation are generated by	additional information.
	whichever modem application
	is in use.
USB Device Problems
You have installed a USB	The device is not properly	Remove and re-install the device. (See Device Ports
device, but your LifeBook	installed.	on page 46 for more information)
notebook does not recog-
	The device may have been	Close the application and restart your notebook.
nize the device, or the
	installed while an application
device does not seem to
	was running, so your notebook
work properly.
	is not aware of its installation.
	Your device may not have the	See your software documentation and activate the
	correct software driver active.	correct driver.
	You may have the wrong I/O	See your device documentation and software docu-
	address selected for your	mentation to determine the required I/O address.
	device.	Change the settings in the BIOS setup utility. (See
		BIOS Setup Utility on page 29 for more information)
	Your device and another device	Check all I/O addresses located within the BIOS
	are assigned the same I/O	setup utility and any other installed hardware or
	address.	software to make sure there are no duplications.
	Parallel port is set to output	Check parallel port setting in the BIOS and set to
	only.	bi-directional or ECP.
ExpressCard Problems
A card inserted in the	The card is not properly	Remove and re-install the card. (See ExpressCards™/
ExpressCard slot does not	installed.	Smart Cards on page 42 for more information)
work or is locking up the
system.

54