Furuno FR-2115-B installation manual Processor, front and top views

8.Run the connector from the card case in front of the GYRO CONVERTER Board as shown in Figure 4-12.

9.Plug the connector from the M-card base assy. in J1 on the RP Board as shown in Figure 4-12.

RP connector

INT Board	GYRO
	CONVERTER
	Board

FRONT

Fasten ground wire from connector with this screw.

(TOP VIEW)

RP Board

ARP Board

SPU Board

J1

Route cable between ARP and SPU Boards.

(FRONT VIEW)

Figure 4-12 Processor, front and top views

10.Fasten the ground wire from the connector with M3X8 pan-head screw and teethed lock washer at the location shown in Figure 4-12.

11.Fasten the PCB card case cover to the processor unit.

12.Connect the monitor cable to the RGB Board. Close the processor unit.

4-12