WARNING
| Do not open the equipment | |
| unless totally familiar with | |
| electrical circuits and | |
| service manual. | |
ELECTRICAL | Only qualified personnel | |
should work inside the | ||
SHOCK | ||
HAZARD | equipment. | |
|
| |
| Wear a safety belt and hard | |
| hat when working on the | |
| antenna unit. |
Serious injury or death can result if someone falls from the radar antenna mast.
Construct a suitable service platform from which to install the antenna unit.
Serious injury or death can result if some- one falls from the radar antenna mast.
Turn off the power at the mains switch- board before beginning the installation.
Fire, electrical shock or serious injury can result if the power is left on or is applied while the equipment is being installed.
Do not install the display unit where it may get wet from rain or water splash.
Water in the display unit can result in fire, electrical shock or equipment damage.
WARNING
Be sure that the power supply is compatible with the voltage rating of the equipment.
Connection of an incorrect power supply can cause fire or equipment damage. The voltage rating of the equipment appears on the label above the power connector.
Use only the specified power cable.
Fire or equipment damage can result if a different cable is used.
CAUTION
Ground the equipment to prevent electrical shock and mutual interference.
Observe the following compass safe distances to prevent interference to a magnetic compass:
| Standard | Steering | |
| compass | compass | |
|
|
| |
Processor | 1.70 m | 0.90 m | |
unit | |||
|
| ||
|
|
| |
Antenna | 1.70 m | 0.90 m | |
unit | |||
|
| ||
|
|
| |
Antenna | 2.10 m | 1.20 m | |
unit | |||
|
| ||
|
| ||
|
|
|
ii
