Functions Description, SYS Config Com Spacing

3 FUNCTIONS

The Functions section allows provides information about Com Frequencies, Internal Communications System (ICS) Configuration, System Configuration (SYS), and Timers (TMR).

3.1Functions Description

Com Freq Recent Freqs

User Freqs

Database

Nearest Apt

Nearest ACC

Nearest FSS

Nearest WX

ICS Config Adjust Intrcom

Aux Audio

Intrcom On/Off

Speaker On/Off

SYS Config Com Spacing

DSPL Brt

DSPL Contrast

Database Info

Load Database

Software Ver

Serial Number

Timers		Count Up
Timers		Count Up
			ENT - Start/Stop
			ENT - Start/Stop
			CLR - Reset
			CLR - Reset
		Count Down
			ENT - Start/Stop
			ENT - Start/Stop
			CLR - Reset
			CLR - Reset
			Push CRSR - Settings
			Push CRSR - Settings
				ENT - Accept
				ENT - Accept
Figure 3-1	Functions Diagram

190-01182-00 Rev. A

Garmin GTR 225/225A/225B Pilot’s Guide

3-1

Page 19

Image 19

Garmin 225B, 225A manual Functions Description, SYS Config Com Spacing

Contents

GTR 225/225A/225B November Limited Warranty Garmin GTR 225/225A/225B Pilot’s Guide Operation US Toll Free Canada Toll Free Product Registration and Support Contents Index Index-1 Photo Sensor Product Description Pilot Controls Power/Com Volume/Squelch Knob MEM Key Tuning LARGE/SMALL Concentric Cursor KnobsFLIP/FLOP Key Com Key Func Function Key USB PortMON Monitor Key Selected Frequency Power OnCom Radio Selecting a Com Frequency Monitor Annunciation Standby Frequency Being Monitored Monitoring the Standby Com ChannelSaving a Com Channel After selecting the desired characters, press ENT Selected Wpt Type After making a selection, press ENT Emergency Channel Com Database Look-UpActive and Standby frequencies Airport Identifier Shown For Freqs In Database Stuck MicFrequency Database Reverse Look-Up Remote Frequency Selection Control This page intentionally left blank Functions Description SYS Config Com Spacing Com Frequencies Press the Func key to access the FunctionsRecent Com Frequencies Press ENT Key To Delete Selected Freq Com User FrequenciesPress the CLR key to delete this User frequency Selected Frequency Select Wpt Name Select Wpt Type Select User Wpt Name Frequencies. Press ENTSelect User Freqs Select User Freq Value Selected Freq As Active Com Database FrequenciesPress ENT Key To Set Selected Freq As Standby Identifier Turn Small Knob To Scroll Through Available Airports Com Nearest Airports APTCom Nearest Area Control Center ACC Frequencies Turn the Small knob to display the available ACCs 13 Com Nearest FSS Frequencies Com Nearest Flight Service Station FSS Frequencies 14 Com Nearest Weather Frequencies Com Nearest Weather WX Frequencies Adjust Intercom ICS Configuration Turn the Small knob to turn the Aux Audio On or Off Aux Audio Speaker On/Off function. Then, press ENT Intercom On/OffSpeaker On/Off Intercom On/Off function. Then, press the ENT key Com Spacing System ConfigurationTurn the Small Knob to Select the Channel Spacing Brightness Display BrightnessSelect the Offset Value Database Version function. Then, press the ENT key Display ContrastDatabase Info Display Contrast function. Then, press the ENT key Load Database function. Then, press the ENT key Load DatabaseUSB Port USB Cable USB Memory Device Serial Number function. Then, press ENT Software VersionSerial Number Press the Func key to return to the main menu Setting Up the Count Down Timer Timers Pressing ENT twice will stop the displayed Timer Setting Up the Count Up TimerViewing Timers in the Com Display Pressing CLR and then ENT will reset the displayed Timer 36 Count Down Timer Value Now Counting Up Count Down Timer Value Highlighted When Counting Up This page intentionally left blank Appendix Troubleshooting Check Mic key input It can be enabledOr disabled via a Remote mounted If in Lock Out mode Updating the Frequency Database Messages Radio will no longer Transmit Power has been Re-apply power to the unitSwitch has been All installations This input will now Installations Index Stuck mic 2-5 Support