![](/images/backgrounds/131332/131332-21823x1.png)
Connecting the access point to network and power
The next step is to set up the network and power connections.
To set up the network and power connections:
1 Connect one end of an Ethernet cable to the network port on the access point and the other end to the same hub where your computer is connected.
Hub
Hub to LAN
Admin computer to hub
Administrator computer
AP to hub
LAN
Access point
OR -
Connect one end of an Ethernet cable to the network port on the access point and the other end of the cable to the Ethernet port on your computer.
Access point
Administrator computer
(This computer must have an IP address on the same subnet as the access point.)
18 | www.gateway.com |