
Starting your system
Before you start your system for the first time:
Refer to the safety information beginning on page 109.
Make sure the voltage selector switch on the back of the computer is set to the correct voltage for your area. This switch is set at the factory to the correct voltage (see “Rear panel” on page 4 for voltage selector switch location).
Make sure all cables are firmly connected to the proper ports on the rear panel of the computer.
Caution Make sure your computer and peripherals are turned off and unplugged from the power outlet when you connect peripherals to the computer.
Make sure the computer and monitor are plugged into an AC outlet or power strip.
To start the system:
1If you have connected the system components to a power strip, make sure all the system components are turned off, then turn on the power strip.
2Turn on the monitor by pressing the power button.
3Turn on the computer by pressing the power button. The power
4Turn on any other components connected to the computer, such as speakers, a printer, or a scanner.
If nothing happens when you turn on the system:
Recheck the power cables to see that they are securely plugged in and that your power strip (if you are using one) is plugged in and turned on.
Make sure the monitor is connected to the computer, plugged into the power strip or AC outlet, and turned on. You may also need to adjust the brightness and contrast controls on the monitor.
12System Setup