Oven Shelves
Clean the shelves with an abrasive cleanser or steel wool. After cleaning, rinse the shelves with clean water, rinse and dry.
CARE AND CLEANING
(continued)
NOTE: The oven shelves may also be cleaned in the
Broiler Pan and Grid
After broiling, remove
the broiler pan and grid from the oven. Remove the grid from the pan.
Carefully pour out grease from the pan into a proper container. Wash and rinse the broiler pan and grid in hot water with a
The enamel grid and broiler pan may be cleaned in the
If food has burned on, sprinkle the grid with detergent while hot and cover with wet paper towels or a dishcloth. Soaking the pan will remove
The broiler pan may be cleaned with a commercial oven cleaner. If the grid is grey enamel, it can also be cleaned with an oven cleaner. If the grid is chrome, do not use an oven cleaner to clean it.
Do not store a soiled pan and grid anywhere in the range.
Both the broiler pan and grid can also be cleaned in the dishwasher.
How to Remove the Storage Drawer to Clean Under the Range
The area under the range can be reached easily for cleaning by removing the bottom drawer. To remove, pull the drawer out all the way, tilt up the front and remove it. To replace, insert glides at the back of the drawer beyond the stop on range glides. Lift the drawer if necessary to insert easily. Let the front of the drawer down, then push in to close.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely.
The oven light bulb is covered with a removable glass cover that is held in place with a
To remove:
1. Hold a hand under the cover so it doesn’t fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover.
DO NOT REMOVE ANY SCREWS TO REMOVE COVER.
2.Do not touch hot bulb with a wet cloth. Replace bulb with a
To replace cover:
1.Place it into the groove of the light receptacle. Pull the wire forward to the center of the cover until it snaps into place. When in place, the wire holds the cover firmly. Be certain the wire is in the depression in the center of the cover.
2.Connect electrical power to the range.
34